Older QEnergySpa/BEFE Array, Water Module


The B.E.F.E. Array was QtheExperience' first mainstream Array. For those of you who may still be using it, below is a step-by-step illustration on how to change the Rings and Track of this water module.
















B.E.F.E. Array

Step 1


Remove the stainless steel Track from the Plates by swinging outwards at an angle and then slide it downwards to extract it from the Top Acrylic Plate. If it is still in good condition, it will need to be unclipped from the Bottom Positive Plate.

Step 2


Place 2 fingers through the holes in the Removable Leg assembly and gently pull it outwards horizontal to the unit. The old Positive Plates should come out with it, but if they don't, gently remove them as well.

Step 3


Slot the new Plates into the slots and gently slide the assembly back into place. Be sure to align the Plates correctly with the appropriate slots in the other Legs. If the assembly does not slot in correctly, do not force it. Double check to make sure that it is all correctly aligned.

Step 4


Slot the top of the Track into the slot in the Top Plate and slide it up and in at the same time. Be sure that the Track contacts are sitting on the top of the Top Plate and the bottom of the Bottom Plate. The Track should click into place.

     Completed Array


QEnergySpa Only



© Copyright 2016 - Future Generation Life Science / QtheExperience Copyright | Disclaimer | Privacy Policy | Contact Details